Cisco Blogs


Cisco Blog > Ideas for State/Local Leaders

Get The Most Out Of Your Construction Money

Construction is a major expenditure for state and local governments. This is going to be the case even more as many billions of dollars will go into infrastructure from the Federal Recovery and Reinvestment Act. It’s also important to realize that construction costs are a major factor in projects that are not officially called construction projects. For example, over the last few years, many governments have invested in public safety radio projects or broadband projects. While these are about communications and technology, often the construction costs associated with these projects are larger than the cost of acquiring the technology.So the key question is whether you are getting the most from every dollar spent on construction. The answer is that, if you just let the construction proceed as it always has been done, you are increasingly wasting money.The construction industry’s productivity picture is below that of US industry, in general. According to the US Bureau of Labor Statistics, productivity in the construction industry has declined since 1968. Stanford University Professor Paul Teicholz reports that”construction work per hourly work hour has gradually declined -- over the past 40 years at an average compound rate of -0.59%/year.” But there is hope on the horizon. A few forward thinking architects, engineers, builders and computer experts have banded together to create a new four dimensional approach to construction projects, which goes by the name”Building Information Modeling” or BIM. Despite the name, BIM can be used in any construction project -highways and sewers, for example -not just buildings.BIM is still a developing technology and approach, so the most dramatic benefits are still in the future. Already, though, those who have used BIM have seen substantial reductions in costs and shrinkage of project schedules. Some have reported reductions of as much as a third over the traditional construction approach. A significant cause of these reductions is that BIM results in a reduction in claims for errors, which traditionally have meant costly rework and ad hoc redesign on the job site. Since BIM coordinates the work of all the trades on a job, it virtually eliminates the problems that ensue when, for example, electrical wiring and water pipes are put in the same place.BIM also enables the prefabrication of customized components. This gives you the savings of pre-fab manufactured buildings, without the need to conform to the manufacturer’s stock designs. For example, a 50 foot component wall could be built off site from the specifications and just be put into place. The US General Services Administration (GSA) has started to require firms who construct federal buildings to use BIM. Hopefully, State and Local governments will also start to require BIM of their construction bidders.For further information about BIM: - The best starting point is a 12 minute video that GSA prepared about their”Journey Into Building Information Modeling” at http://www.gsa.gov/Portal/gsa/ep/contentView.do?contentType=GSA_BASIC&contentId=24256- This video is part of a general GSA website devoted to BIM at http://www.gsa.gov/bim. It includes all kinds of publications that you might want to pass along to your public works or other construction staff.- The buildingSMART alliance is the organizational leader of BIM. Its”focus is to guarantee lowest overall cost, optimum sustainability, energy conservation and environmental stewardship to protect the earth’s ecosystem.” http://www.buildingsmartalliance.org/- Wikipedia, of course, has an entry on BIM at http://en.wikipedia.org/wiki/Building_Information_Modeling- An introductory article,”Intelligent Design Through BIM” can be found at http://www.allbusiness.com/technology/software-services-applications-computer/11579683-1.htmlNorm Jacknis njacknis@cisco.com February 22, 2009

Comments Are Closed